Repairs · 7 minute read

Mould in a Rental Property NSW – Who Fixes It and How to Stop It Coming Back

  • 10+ years on the toolsSydney and the Central Coast
  • Licence 399743CVerifiable on the NSW register
  • $10M public liabilityInsured with NRMA
  • Cert IV BuildingPlus Cert III Carpentry
  • 5/5 on GoogleFrom 15+ reviews

The short answer

In NSW, the landlord must fix mould caused by a building defect or poor ventilation, such as a leaking roof, a failed shower or a fan that vents into the roof space, and the tenant may be responsible if they let moisture build up by not ventilating the home. Mould may be an urgent repair if the fault makes the home unsafe. Cleaning it off only buys time until the water source is fixed.

Caused by a defect or poor ventilation
Landlord’s to fix
Caused by moisture the tenant let build up
Tenant may be responsible
Urgent repair?
It may be, if it makes the home unsafe
Tenant’s duty
Report mould or damp as soon as possible

Who Is Responsible for Mould in a Rental Property in NSW?

Responsibility follows the cause: the landlord fixes mould that comes from a building fault or inadequate ventilation, and the tenant may be responsible for mould caused by how they used the home. Neither side can call it until the source of the moisture is known.

The NSW Government’s page on mould in a rental property gives two examples that set the line. If mould grew because the landlord failed to repair a defective window in a reasonable time, or because the property did not have adequate ventilation, the landlord is responsible and must fix it. If mould developed because the tenants never opened a window or did not use the bathroom fan, the tenant may be responsible.

The legal hook is the fit-for-habitation test in section 52 of the Residential Tenancies Act 2010. Adequate ventilation is one of the seven minimum standards for rental properties, and the Act says a home is only structurally sound if its floors, ceilings, walls and supporting structures are not subject to significant dampness, and its roof, ceilings and windows do not let water in. A roof leak or a failed shower that keeps a wall wet is a landlord’s problem under that test, whatever the tenant does with the windows.

Is mould that appears early in a lease pre-existing?

It can be. NSW’s guidance says mould that develops close to the start of a tenancy could be considered pre-existing damage.

The same page notes that the property condition report has a dedicated section on mould. A careful ingoing report, with photos of ceilings, wardrobes and wet areas, is the best protection for both the owner and the tenant.

Does noting mould on the condition report end the landlord’s duty?

No. Even if mould is noted on the condition report, the landlord must still keep the property in a reasonable state of repair.

Recording a stain does not make the leak behind it acceptable. If the cause is a building defect, it still has to be fixed. Our guide to rental property minimum standards in NSW covers the other six standards an owner must keep up through the lease.

Is Mould an Urgent Repair in NSW?

Mould may be an urgent repair when the fault behind it makes the property unsafe and causes a health risk, but it is not automatically urgent. The cause usually decides it.

NSW’s mould page says that if there is a fault or damage that makes the property unsafe and causes health risks such as mould, this may be an urgent repair. Several of the faults that feed mould are on the official list of urgent repairs in their own right, including a serious roof leak, a burst water service, flooding or serious flood damage, and serious storm damage. The tenant must tell the landlord or agent about urgent repairs straight away.

If a tenant cannot reach the landlord or agent, NSW’s guide to getting repairs done lets them arrange an urgent repair and have the reasonable costs reimbursed up to $1,000, paid back within 14 days of their notice. Mould is also a health matter. NSW Health’s mould fact sheet says people with asthma, allergies or other breathing conditions may be more sensitive to it, which is worth knowing when deciding how fast a job needs to move.

How fast does a non-urgent mould repair need to happen?

Within a reasonable time, which NSW does not set as a fixed number of days.

The getting repairs done page says non-urgent repairs must be done to keep the property in reasonable condition, and a tenant who is not getting action can ask NSW Fair Trading for help, which may issue a rectification order, or take the dispute to the Tribunal. A written scope with a start date settles most of these before they get that far.

What Causes Mould in a Rental Property?

Moisture causes it, and in a rental that moisture comes from one of two places: water getting into the building, or water vapour from daily living that has nowhere to go. Where the mould sits usually points to which one it is.

NSW Health puts it simply: mould needs moisture and nutrients to grow, and if moisture accumulates, mould will often grow on indoor surfaces. Its fact sheet tells households to run exhaust fans when showering, cooking and drying clothes, to repair water leaks and plumbing problems, and notes that poor sub-floor ventilation or moisture in the sub-floor makes rising damp worse. On a coastal block that is often damp underneath and salty above, these are the patterns that come up again and again:

  • Black spots across the bathroom ceiling: usually a fan that is too weak, never runs long enough, or blows steam into the roof space instead of outside.
  • Mould low on walls and behind skirting boards: often damp rising from a wet subfloor, blocked vents or poor drainage around the house.
  • Mould around window frames and sills: condensation on cold glass in winter, or water getting past failed seals and flashings when it rains.
  • Mould on a wall next to the shower, or soft carpet outside it: a classic sign of failed waterproofing, which no amount of cleaning will fix.
  • Mould inside a built-in wardrobe on an outside wall: cold surfaces and still air, sometimes made worse by a leak in the wall above.
  • A brown ring on the ceiling with mould inside it: a roof, gutter or flashing leak, usually worse after heavy rain.

How can you tell condensation mould from a leak?

Condensation mould is spread thinly across cold surfaces and gets worse in winter, while leak mould sits in one patch, often with a stain, and gets worse after rain.

Condensation shows up on the coldest parts of a room: ceilings near external walls, the corners of a wardrobe, the glass and frames of windows. A leak leaves a tide mark, swollen or soft timber, peeling paint and a smell that lingers after the room has dried out. A moisture meter and a look in the roof space or under the floor usually confirm it in one visit.

What Should a Property Manager Do When a Tenant Reports Mould?

Record it, inspect it, find the cause, then fix the cause before anyone cleans or paints. That order protects the owner, the tenant and the agency if the matter ends up in a dispute.

Tenants must tell the landlord or agent as soon as possible when they see signs of mould or damp. From there, a workflow that holds up looks like this:

  • Acknowledge the report in writing and ask the tenant for photos, how long it has been there and whether it changes after rain.
  • Book an inspection with the right notice. NSW’s minimum notice periods for access require at least 2 days’ notice to carry out or assess necessary repairs, and none for urgent repairs.
  • Have the moisture source diagnosed by someone who will look in the roof space, under the floor and behind the wet areas, not just at the stain.
  • Send the owner a written scope that names the cause, the repair and what is excluded, with photos.
  • Fix the cause first, then clean, treat or replace the affected linings, and record the result with dated photos.
  • Note it at the next routine inspection so the file shows the repair held.

Who pays if the tenant and owner disagree about the cause?

The evidence decides it, and a builder’s written view of the cause is often the piece that is missing.

Fair wear and tear, damage and disrepair turn on the same question as mould: what caused it. Our guide to fair wear and tear vs damage in NSW explains how the condition report and repair records settle who pays.

What Building Work Stops Mould Coming Back?

Work that removes the moisture: exhaust fans that vent outside, roof and window leaks sealed at the source, failed shower waterproofing replaced, and a subfloor that can breathe. Bleach and a fresh coat of paint are cleaning, not repairs.

When a fan is installed or replaced today, the National Construction Code sets the bar. Part 10.8 of the NCC 2022 Housing Provisions requires a minimum flow rate of 25 L/s for a bathroom or sanitary compartment and 40 L/s for a kitchen or laundry, with the exhaust discharged directly, or through a shaft or duct, to outdoor air. Where a bathroom has no natural ventilation under the code and relies on a fan that does not run all the time, the code calls for that fan to be interlocked with the light and to keep running for 10 minutes after. Many older rentals were built before these rules, which is why a weak fan ducted into the roof space is so common.

The other fixes depend on what the diagnosis finds:

  • Roof and gutter leaks: repair the flashing, tiles or gutters, then replace any ceiling lining that stayed wet.
  • Windows: reseal or reflash, replace rotted sills and frames, or replace the window where it is beyond repair.
  • Showers: a leaking shower usually means the waterproofing under the tiles has failed. It needs a properly scoped bathroom renovation rather than fresh grout.
  • Subfloors: clear blocked vents, fix drainage that runs under the house, and replace rotted bearers or joists.
  • Electrical work: wiring a new fan or timer is a job for a licensed electrician, booked as part of the same scope.

So Who Should Fix Mould in a Rental Property?

The landlord should fix the building fault behind the mould, and the tenant should report it early and keep the home ventilated. When the cause is unclear, a builder’s inspection and written scope settles it faster than another round of cleaning.

Most recurring mould in Central Coast rentals traces back to a handful of faults: fans that do not vent outside, leaking showers, tired roofs and window flashings, and damp subfloors. Find the one that applies, fix it once, and keep the paperwork.

Williamson Builds carries out rental and strata repairs for property managers and landlords across all of the Central Coast, with Newcastle and Sydney by arrangement for larger jobs, under builder’s licence 399743C with $10 million in public liability cover. See our page on home repairs and maintenance for the jobs we take on. This guide is general information for NSW and is not legal or health advice, so check the NSW Government pages linked above for the current rules.

Written by

Hamish Williamson

Director and licensed builder, Williamson Builds, licence 399743C

Hamish has spent more than ten years on the tools, including high-end residential work in Dee Why and Annandale before starting Williamson Builds on the Central Coast. He checks every guide on this site before it goes up.

NSW licence 399743C · Certificate III in Carpentry · Certificate IV in Building and Construction. Search the licence number on the Building Commission NSW register.

Last reviewed 29 October 2026

More about Hamish and Williamson Builds

GET MY FREE QUOTECall 0420 221 420

Hamish Williamson, director and licensed builder at Williamson Builds

Start here

Tell Us About Your Job

A sentence and a couple of photos is enough for us to know how to help. If someone else is the better call, we’ll say so in the reply.

  • Licence 399743C
  • Public liability insured
  • 5/5 from 25+ Google reviews

Get a free quote

Name

We reply within one working day. No obligation, no sales call.

Call 0420 221 420