Fences · 7 minute read

Fence Height Rules NSW – How High Can a Fence Be Without Council Approval?

  • 10+ years on the toolsSydney and the Central Coast
  • Licence 399743CVerifiable on the NSW register
  • $10M public liabilityInsured with NRMA
  • Cert IV BuildingPlus Cert III Carpentry
  • 5/5 on GoogleFrom 15+ reviews

The short answer

Williamson Builds’ quick answer: in most NSW residential streets a side or rear boundary fence can be up to 1.8 metres high without council approval, and a fence along the street can be up to 1.2 metres. A masonry fence is limited to 1.2 metres in either spot. Those heights come from the state’s exempt development rules, and extra conditions apply on bushfire prone, heritage and flood affected land, which takes in a lot of the Central Coast.

Side and rear
Up to 1.8 m
Street front
Up to 1.2 m
Masonry
Up to 1.2 m
Boundary pool fence
1.8 m as a pool barrier

How High Can a Fence Be Without Council Approval in NSW?

Up to 1.8 metres on a side or rear boundary and up to 1.2 metres along a road, if the fence meets the rest of the exempt development standards.

A fence that meets every standard is exempt development, which means no application to council and no certifier. The NSW Planning Portal’s page on fences as exempt development sets out the standards for the residential zones (R1 to R4 and RU5) that cover most Central Coast streets:

  • Side and rear boundary fences “must not be higher than 1.8 metres, or 1.2 metres if the fence is built from masonry.”
  • Fences along a road boundary, or in the setback area to a road, “must not be taller than 1.2 metres”.
  • Gates must not open outwards.
  • Metal parts must be low reflective, factory pre-coloured materials.
  • No electric fencing or barbed wire.

How high can a front fence be?

1.2 metres, and that limit applies to more than the fence on the front boundary.

The 1.2 metre limit covers any fence in the setback area to the road, which in practice is the part of your yard forward of the house. A side fence can’t run at 1.8 metres all the way to the footpath. It steps down to 1.2 metres where it enters the front setback.

What about a corner block?

The side that faces the second street is treated as a road boundary, so it is limited to 1.2 metres as well.

The Planning Portal says the 1.2 metre rule “includes the front of the site and any side boundary on corner sites.” A fence along the secondary road must also “be at least 20 per cent transparent, above 400 millimetres” and can’t have solid piers or posts wider than 350 millimetres. Corner blocks are where most over-height fences come from, because the owner wants privacy for a back yard that sits beside a street.

Are the rules different on acreage?

Yes. In rural and environmental zones an exempt fence can be up to 1.8 metres, and it has to be post and wire or post and rail.

Masonry is only allowed within three metres either side of the entrance from the main road. A solid paling or Colorbond boundary fence is not automatically exempt in these zones. On acreage blocks around Matcham and elsewhere behind the coast, check the zoning of the block before choosing the fence.

When Does a Fence Need Council Approval on the Central Coast?

When it is higher than the exempt limits, or when the land itself has a constraint the exempt rules don’t allow for.

The Planning Portal is clear that exempt development “must meet all of the development standards”. Miss one and the fence needs approval. On the Coast, three constraints come up again and again.

Hardwood slat privacy fence, a Williamson Builds job at MacMasters Beach on the Central Coast
A hardwood slat privacy fence on a job at MacMasters Beach.

What if your land is bushfire prone?

The fence has to be built from non-combustible materials or hardwood to stay exempt.

That is the Planning Portal’s wording, and it rules out a standard treated pine paling fence on those blocks. Hardwood, steel and masonry are the options. You can check an address on the NSW Rural Fire Service’s bush fire prone land tool in a minute, and it is worth doing before you compare quotes.

What if the property is heritage listed?

Expect to need council’s approval before changing the fence.

Exempt development generally can’t be carried out on land listed on the State Heritage Register. Locally, Central Coast Council’s heritage page counts 364 local heritage items and says that for some work to heritage items and properties in heritage conservation areas, “a Development Application will need to be lodged for council approval.” Minor works can sometimes go through Council’s heritage exemption form, which has to be approved in writing first.

What about flood prone land and overland flow?

A solid fence across a flow path can need approval, because it can dam or divert water onto a neighbour.

Council’s page on development in flood zones calls boundary fences and gates that “impede natural overland flow paths” a common problem in built up areas, says “fences should allow water to safely pass”, and warns that these works “may require development approval if located within a floodplain or overland flow path.” Around the lakes, Brisbane Water and the creek lines, ask Council before settling on a solid fence.

Can you build a fence higher than 1.8 metres?

Only with approval. Once a fence goes over the exempt height it needs a development application to Central Coast Council.

Council then looks at what the extra height does to the neighbours and the street. If a neighbour dispute over height ends up at the tribunal, it can set the height too: the State Library of NSW’s guide to dividing fences describes a case where the tribunal ordered a new fence at 1800 mm, “the maximum height allowed under their local council regulations.”

Does a Pool Fence Follow the Same Height Rules?

No. A pool fence is a safety barrier with its own measurements, and the rules for it are stricter than for an ordinary fence.

The NSW Government’s pool owner obligations say “a pool fence must be at least 1.2m high”, measured from finished ground level, and “if a boundary fence is part of the pool fence, the barrier must be 1.8m high.” Gaps under the fence and between vertical bars can’t be more than 10 cm, and nothing climbable can sit within the 90 cm non-climbable zone. If your boundary fence doubles as the pool barrier, replacing it is pool compliance work as well as fencing, and councils enforce it.

Do You Need Your Neighbour’s Agreement to Build a Boundary Fence?

Yes. A fence on a shared boundary is a dividing fence, and the work has to be agreed by both owners.

The Planning Portal notes that where a fence separates you from an adjoining lot, “the Dividing Fences Act 1991 applies.” Legal Aid NSW’s guide to fencing rights and obligations puts it plainly: “Fencing work on a dividing fence must be done with the agreement of both owners of neighbouring property”, and “any agreement should be written down and signed by you and your neighbour.”

The law works on the idea of a “sufficient dividing fence”, one that adequately separates the two properties. What counts depends on the existing fence, how each property is used, privacy, the fences usual in the area and council’s requirements. A neighbour who wants something of a higher standard than that is responsible for the difference.

What is a fencing notice?

It is the written notice one owner gives the other when they can’t agree, and it starts the formal process.

There is no set form. Legal Aid NSW’s step-by-step guide to a fencing notice says it should describe the fencing work, “including the length and height of the fence and the materials to be used”, along with where it will go, who will do it and when, and recommends attaching a written quote. If there is still no agreement a month after the notice is served, either owner can apply to NCAT or the Local Court, and the orders NCAT can make include “how high the fence should be”.

Is the old fence on the boundary?

Not always, and it is worth knowing before the new one goes in.

Legal Aid NSW’s fences and boundaries FAQs note that a fence that is not exactly on the boundary line is still a dividing fence under the Act, and that neighbours can have a registered surveyor mark the line. If there is any doubt, settle it first. Moving a new fence later means building it twice.

Does a retaining wall count as part of the fence?

Only if the wall is needed to support the fence.

Legal Aid NSW says a retaining wall is not covered by the Dividing Fences Act unless it is necessary for the support and maintenance of the dividing fence, and advises checking with your local council before any work on one. On a sloping Central Coast boundary the fence and the wall under it are often one job, and they need to be scoped together.

Who Can Build a Fence in NSW?

A licensed contractor, once the job is worth more than $5,000 in labour and materials.

Building Commission NSW’s page on fencing work says “you must have a licence or certificate to do fencing work”, and that a contractor licence is needed for any residential fencing valued above that threshold, including GST. Timber fencing also sits within a carpentry licence, and a general building licence covers it along with any retaining wall, gate or deck it ties into.

Two checks before any post hole is dug. Lodge a free Before You Dig Australia request for plans of the pipes and cables under the fence line. And ask the council before removing or pruning trees and vegetation along the boundary, which the Planning Portal flags as a separate approval question.

So How High Should Your Fence Be?

For privacy at the side and back, 1.8 metres is what most people want and the most you can build without approval. At the front, stay at 1.2 metres or under. Check the bushfire, heritage and flood status of the block before choosing the material, and get your neighbour’s agreement in writing before anyone orders timber.

Most fence trouble starts with one of those four being skipped: a fence that went up too high on a corner, pine palings on a bushfire prone block, a solid fence across a flow path, or a neighbour who was told and not asked. All four are easier to sort out on paper than after the posts are in concrete. If the fence you have is leaning or rotten at the posts, our home repairs and maintenance page covers when a repair will do, and our guide to council approval for decks and pergolas covers the same exempt development rules for the rest of the yard.

Williamson Builds is a licensed builder, licence 399743C, covering all of the Central Coast, with Newcastle and Sydney by arrangement for larger jobs. This guide is general information for NSW and is not legal advice. The Planning Portal and Central Coast Council have the final say on what applies to your address.

Written by

Hamish Williamson

Director and licensed builder, Williamson Builds, licence 399743C

Hamish has spent more than ten years on the tools, including high-end residential work in Dee Why and Annandale before starting Williamson Builds on the Central Coast. He checks every guide on this site before it goes up.

NSW licence 399743C · Certificate III in Carpentry · Certificate IV in Building and Construction. Search the licence number on the Building Commission NSW register.

Last reviewed 9 October 2026

More about Hamish and Williamson Builds

GET MY FREE QUOTECall 0420 221 420

Hamish Williamson, director and licensed builder at Williamson Builds

Start here

Tell Us About Your Job

A sentence and a couple of photos is enough for us to know how to help. If someone else is the better call, we’ll say so in the reply.

  • Licence 399743C
  • Public liability insured
  • 5/5 from 25+ Google reviews

Get a free quote

Name

We reply within one working day. No obligation, no sales call.

Call 0420 221 420